Guides › Loop
How to solve Slitherlink (Loop) puzzles
Slitherlink asks you to draw a single closed loop along the lines of a dot grid. Each number says how many of the four sides of its cell are part of the loop; empty cells are free. The loop never crosses or branches, so every dot has either two lines or none. Loop is DailyLogic’s daily Slitherlink; here is how to solve it without guessing.
1. Mark the sides that cannot be lines
Half of Slitherlink is writing down what is not there. Put an ✕ on every side you rule out; the forced lines then show themselves.
- A 0 has no sides: ✕ all four.
- A 3 next to a 0 has its three other sides drawn, and the loop continues past the shared ✕ on both ends.
- A dot that already has two lines gets ✕ on its remaining sides. A dot with three ✕ gets a fourth: a single line cannot end there.
2. The 3 patterns
- 3 in a corner: both outer sides are lines. The loop cannot turn inside the corner, so the two sides along the edge of the grid are part of it.
- Two 3s side by side: the line between them is drawn, and so are the two outer sides. The remaining sides of that pair alternate, which usually fixes the next cell as well.
- Two 3s diagonal: the two sides of each 3 that face the other are lines. Four lines around their shared dot would be impossible, so the loop wraps around the outside.
- 3 next to a 1 on the edge: the 1 cannot use the side it shares with the 3’s edge path; mark it and the 3 is often complete.
3. The 1 and 2 patterns
- 1 in a corner: both outer sides are ✕. A line entering the corner would have to leave through the other outer side, giving the cell two lines.
- 2 in a corner: the two outer sides are either both drawn or both empty. Follow the loop out of the corner; one of the two cases will break a neighbour.
- A line reaches a corner dot of a 1 and cannot continue past the cell (its exit away from the 1 is ✕): it must run along one side of the 1, so the two sides of the 1 that do not touch that dot are ✕.
- A line reaches a corner dot of a 2 and its other exit at that dot, away from the 2, is ✕: the line runs along the 2, and exactly one line leaves the cell at the diagonally opposite corner.
4. Follow every loose end
A line that enters a dot must leave it. Pick any line end and look at the dot: if two of the other three sides are ✕, the third is a line. If the only exits would give a number too many sides, they are ✕ and the line turns the other way. Chasing loose ends solves more cells than any pattern.
5. Never close a small loop
The answer is one loop. If joining two line ends would close a loop before every number is satisfied, that join is ✕. Near the end of a puzzle this rule alone finishes several dots.
6. Inside and outside
Every cell is either inside the loop or outside it. A loop line separates an inside cell from an outside cell; an ✕ joins two cells on the same side. Cells touching the border of the grid are outside if no line separates them from it. When two cells are both known to be inside, the side between them is ✕; when one is inside and one outside, it is a line. Parity along a row also helps: crossing the loop an even number of times from the left edge leaves you outside.
7. Finish by counting
In the last stretch, count the lines each remaining number still needs against the sides it still has free. When they match, every free side is a line. Every Loop board is checked by a solver to have exactly one loop, so there is always a forced step somewhere.
Sizes
The daily ladder runs from 4×4 to 7×7 over ten levels; unlimited mode has 5×5, 6×6 and 7×7.
Related puzzles
Trail is the other line-drawing puzzle on DailyLogic, with a single path instead of a loop. Bridges also uses “everything must connect” reasoning, and Blocks shares the habit of marking what cannot be before placing what must.